Mass and Motion
Results & debates

Record-breaking attosecond hard X-ray pulses achieve unprecedented intensity

Researchers at the European XFEL have generated attosecond hard X-ray pulses with a record intensity of 118.8 GW, focused to a spot measuring 180 by 330 nanometers. This breakthrough enables the direct imaging of electron motion in atoms and molecules on their natural timescale.

Researchers at the European XFEL have generated attosecond hard X-ray pulses with a record intensity of 118.8 GW, focused...

Record-breaking attosecond hard X-ray pulses have reached an unprecedented intensity, opening a new window for imaging electron motion. The European XFEL team generated pulses with a record intensity of 118.8 GW focused on a spot measuring 180 by 330 nanometers, achieving a power density of 2 x 10^20 watts per square centimeter. This makes the flash about ten times more intense than any attosecond X-ray laser pulse reported before.

Each pulse lasted mere attoseconds, or billionths of a billionth of a second. The team ran the experiment in April 2026. Scanning fine gold wires across the beam confirmed the focal spot was a few hundred times narrower than a human hair. Measured just past the focusing magnets, each flash carried 140 microjoules on average, more than ten times the energy of earlier hard X-ray attosecond pulses.

Technical breakthrough in pulse generation and compression

The pulses were produced using the XFEL's electron bunch compression and precision mirror focusing system to achieve unprecedented power density. The machine starts with a tightly packed bunch of electrons lasting just a few femtoseconds. The XFEL is a linear electron accelerator using self-amplified spontaneous emission to generate coherent light.

The pulses were focused using an Advanced Kirkpatrick-Baez (AKB) mirror system developed by Jumpei Yamada and Ichiro Inoue. Each flash bounced four times inside a vacuum chamber, with one mirror focusing it vertically and the other horizontally. A curved diamond crystal recorded the spread of energies in every flash without disturbing it.

Of 74,000 flashes analyzed, 13.7% showed a single spike, consistent with the light coming from one ultrashort slice of the electron bunch. Their energy spread of 6 electronvolts implies a duration of about 300 attoseconds, if each pulse is as short as its spectrum allows.

Enabling 3D electron motion imaging

The intense, focused pulses allow monitoring of electron motion through pulse distortion, enabling 3D maps and movies of ultrafast dynamics. Flashes this short and intense are meant to show what electrons do before the X-rays change the sample. The pulses can image material structure before electronic damage develops, improving measurements of radiation-sensitive samples.

Physicists judge a flash by two numbers once it reaches a sample: fluence and intensity. The achieved figures were roughly ten times the previous best for attosecond X-ray laser pulses.

MetricValue
Pulse Duration~300 attoseconds
Peak Power118.8 GW
Focal Spot Size180 x 330 nm
Peak Intensity2 x 10^20 W/cm²
Pulse Energy (avg.)140 µJ
Fluence67,000 J/cm²

The team wanted an independent check on that intensity. They shone the pulses onto a copper foil. A 10,000-electronvolt X-ray photon can knock an electron out of the innermost shell of a copper atom. When another electron drops into that hole, the atom gives off an X-ray of its own. At high enough intensity, those X-rays stimulate neighboring excited atoms to emit in the same direction, a process called amplified spontaneous emission (ASE).

The copper glow climbed steeply as pulse energy rose to about 20 microjoules, slowed after that, and leveled off above 50 microjoules. One possible reason for the leveling is that the pulse strips electrons out of the atoms faster than the atoms can glow. The estimated intensity was close to the level at which this electron stripping should occur, supporting that explanation. Researcher Jiawei Yan said, "We undertook this new study to see whether we could tightly focus these pulses to increase their intensity."

Only about one flash in seven came out as a single spike, and the leveling of the copper glow has one possible explanation rather than a proven one. The team wrote that pulses this intense could drive higher-order interactions between X-rays and matter and capture a structure before the X-rays damage it. Split into two timed flashes, they might also control how electrons move in atoms and molecules.

European XFEL expects its own focusing mirrors in early 2027, funded with the University of Hamburg and Germany’s research ministry. Future work aims to study nonlinear X-ray interactions and ultrafast electronic dynamics. "I would also like to see more experiments using these pulses to study nonlinear X-ray interactions and ultrafast electronic dynamics," said Jiawei Yan. The full study was published in the journal Optica.

Related coverage

More from Results & debates